#SERIAL EEPROM PROGRAMMER 93C56 HOW TO#The software example shows how to use the MSP430 USART and USCI module for communication with EEPROM via I2C bus. This applies for example to the Native POSIX execution (native_posix) board: west build -b native_posix samples/drivers/eeprom west build -t run. It is advised that users be familiar with the eeprom types and connections. Really, this is the function you should use to preserve the EEPROM memory. As I understand it, that should reserve a 1024 byte window near the end of EEPROM for my permanent. This micro-controller has 1KByte of EEPROM in the address range 0x4000 – 0x43ff. There in no I2C EEPROM chip populated on the HDK. The library is cool except for that it is written by keeping in mind all the possible controllers in the STM8S/A 8-bit. The ability to choose your own voicing patches from growing list for FV-1 builds is quite the convenient service. I2C With EEPROM FT256A, ATC24256A and RTC DS3231 Using DriverLib STM8S. 3 Blockdiagram Figure1:STM8S005xxvaluelineblockdiagram XTAL1-16MHz RCint.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |